I have been adding my equipment now for about 45-60 minutes using the All Property page. Every time I add a SN I have to save and then I have to click the edit button to add another SN. Is there a way where the program can be set up so while I am under a certain LIN#, I can edit all property of that LIN and then save it all at the same time? That, I believe, would cut time going back and forth and make it a more user friendly program.
Thanks again,
Drclonkous
I have been adding my equipment now for about 45-60 minutes using the All Property page. Every time I add a SN I have to save and then I have to click the edit button to add another SN. Is there a way where the program can be set up so while I am under a certain LIN#, I can edit all property of that LIN and then save it all at the same time? That, I believe, would cut time going back and forth and make it a more user friendly program.
Thanks again,
Drclonkous :geek: